Make IOT project with

Surilli BASIC

Surilli Basic


Surilli Basic is the new development board from Silverback, it is thin, light, and allows you to fly.

Description


Surilli Basic is the new development board from Silverback, it is thin, light, and allows you to fly.

Surilli basic M0 is Arduino-compatible with in-built USB and battery charging. Heart of Surilli Basic M0 is ATSAMD21G18 ARM Cortex M0 processor, clocked at 48 MHz and at 3.3V logic, the same controller used in Arduino M0. This chip has 256K of FLASH (8x more times than Atmega328 or 32u4) and 32K of RAM (16x more times). This chip comes with inbuilt USB-to-Serial program & debug capability so there is no need for an FTDI chip.

To make standalone projects, a JSTPH connector is added for any of 3.7V Lipo batteries and built in battery charging. It will run just fine from USB 2.0. But, if you have battery, then plug USB in to the laptop to charge the battery. The Surilli Basic M0 will automatically switch over to USB power when it’s available.

The Surilli Basic M0 has some extra space left over, so there is a tiny little prototyping area. If you just need to attach a button or sensor, you may be able to skip out on a breadboard and wire it directly on it. Comes fully assembled and tested, with a USB bootloader that lets you quickly use it with the Arduino IDE.

SHOW NOW

Here's some handy specs! Like Surilli Basic M0 you get:

  • Measures 62mm x 23mm x 8mm without headers soldered in
  • Light weight - 4.5 grams
  • ATSAMD21G18 @ 48MHz with 3.3V logic/power
  • 256KB of FLASH + 32KB of RAM
  • No EEPROM
  • 32.768 KHz crystal for clock generation & RTC
  • 3.3V regulator with 500mA peak current output
  • USB native support, comes with USB bootloader and serial port debugging
  • Available pins - 20 GPIO pins
  • Hardware Serial, hardware I2C, hardware SPI support
  • PWM outputs on all pins
  • 6 x 12-bit analog inputs
  • 1 x 10-bit analog output (DAC)
  • Built in 100mA li/poly charger with charging status indicator LED
  • Pin #13 red LED for general purpose blinking
  • Power/enable pin
  • 4x2 power pins header
  • 2 mounting holes
  • Reset button

Surilli Basic Datasheets

Surilli Basic Tutorials

Online support through

Email: support@surilli.io

Facebook Group: https://www.facebook.com/groups/190887191659395/

Whatsapp No: +923377874554

Plug Features


Mouse over the components of device to show Components

USB type A Battery jack ARM Cortex-M0 Screw slot for mounting the device Screw slot for mounting the device Screw slot for mounting the device Proto space for adding sensors, actuators or communication modules of choice.